Dear Ampro,
 
I guess the data you have put is been interpolated as you need to convert point
data into continuous surface. I have done some work for possible selection of
interpolation in software other than MODFLOW. Once I am ready with result I will
be in postion to clarify the same.
 
Regards
 
Suparn Pathak


--- On Fri, 7/4/08, Amparo Edwards <aedwards@...> wrote:

From: Amparo Edwards <aedwards@...>
Subject: [visual-modflow] Problems with the initial condition
To: visual-modflow@...
Cc: "Felipe" <forellana@...>
Date: Friday, July 4, 2008, 3:27 PM

Hi,

I am a civil engineer from Chile, I work in groundwater exploration.

I have two doubts about Visual MODFLOW:

1.- I found a difference between the water level in a cell if I see it from
the cell inspector and from the data exportation (in a steady model). Which
of these is the real water level?

2.- When I run a model in the transient condition the water level in the
initial time at a point is different from the level in the steady condition
(which was used as initial condition). Why?

I hope someone can tell me something about the problems I am facing.

Thanks!

Amparo Edwards S.
Ingeniero Civil Hidráulico U. de Chile